| SkullandBonesSkateboards.com Forum Index » SCREEN PRINTING » new hat and shirt printing jigs! |
|
Page 1 of 1 |
|
| Author |
Message |
| infamouscody |
 Posted: Mon Sep 19, 2005 9:23 am |
 |
|
|
Joined: 05 Sep 2005
Posts: 156
Location: florida
|
|
| Back to top |
      
|
|
|
| infamouscody |
| Posted: Mon Sep 19, 2005 9:11 pm |
|
|
|
Joined: 05 Sep 2005
Posts: 156
Location: florida
|
|
| Back to top |
|
| kilwag |
| Posted: Mon Sep 26, 2005 1:28 pm |
|
|
|
Joined: 06 Jul 2004
Posts: 40
Location: Portland OR,
|
NIce. shows what you can do with a little drive and a restricted budget.
If you find that those clamps don't hold your registration well try using a quick release clamp. They can cost about $7-15 a piece but are worth it if they keep you from printing stuff you can't sell.
Here'sa couple differnt examples. They are a lot sturdier than spring clamps.
 |
|
|
| Back to top |
|
|
|
| infamouscody |
| Posted: Mon Sep 26, 2005 1:42 pm |
|
|
|
Joined: 05 Sep 2005
Posts: 156
Location: florida
|
| yea those are good. i have some in my shop, but they were being used at the time.. thnx |
|
|
| Back to top |
|
|
