| SkullandBonesSkateboards.com Forum Index » GENERAL DISCUSSION FORUM » Rannalli pivot cup replacement??? |
|
Page 1 of 1 |
|
| Author |
Message |
| TovinoThomas |
 Posted: Sat Apr 27, 2019 6:20 am |
 |
|
|
Joined: 25 Apr 2019
Posts: 6
Location: USA
|
nyone know what pivot cups work as replacements for Rannalli trucks?
I replaced the bushings with some Khiros last summer but didn't bother replacing the pivot cups. Now the pivot cup in one truck has crumbled completely and the other was well on its way to catastrophic failure. The OG cups are smaller than my Indy stage 11's, OG Gullwing Super Pro III's, 9" Gullwing Pro's and Tacker Gnarly pivots.
The outside diameter of the pivot cup measures 9/16" or about 14mm. Here is a pic of whats left of the pivot cup that I pulled out. https://scrabblewordfinder.vip/ https://www.applock.ooo/ https://www.7zip.vip/ |
Last edited by TovinoThomas on Sat Apr 27, 2019 1:50 pm; edited 1 time in total |
|
| Back to top |
 
|
|
|
| slob-air |
| Posted: Sat Apr 27, 2019 11:45 am |
|
|
Site Admin
Joined: 27 Oct 2001
Posts: 63528
Location: S&B HQ
|
|
| Back to top |
 
|
| gheepup |
| Posted: Sun May 05, 2019 8:10 pm |
|
|
|
Joined: 24 Dec 2008
Posts: 418
Location: PNW
|
Did they look anything like this?
My other one crumbled completely to nothing. I had a real tough time finding anything that fit. I ended up custom cutting some rubber pivots that I found on a roller skate supply site. I don't remember the name of the site nor do I like rubber pivot cups.
I too would like to find some urethane pivot cups that fit Rannalli trucks properly. |
|
|
| Back to top |
|
|
|
|
