SkullandBonesSkateboards.com Forum Index » SCREEN PRINTING » Screening a solid color on a deck. |
Page 1 of 1 |
|
Author |
Message |
parasight |
Posted: Thu May 03, 2012 7:23 am |
|
|
Joined: 27 Sep 2005
Posts: 439
Location: SW PA
|
I want to screen my deck a solid color to start off, then once it dries go back and do another image on top of that. To screen the solid color do I have to burn a silohette of my deck's shape on the screen first or can I just use the blank screen without any image burned to it? |
|
|
Back to top |
|
|
kirb-slider |
Posted: Thu May 03, 2012 7:59 am |
|
|
ORDER OF THE SKULL
Joined: 20 Feb 2009
Posts: 6219
|
Blank screen will be hella messy. If its just one or two at least tape around your shape. |
_________________ YOU CAN'T PAY YOUR DUES WITH CASH
~nostalgia is the wave of the future~ |
|
Back to top |
|
parasight |
Posted: Fri May 04, 2012 8:27 pm |
|
|
Joined: 27 Sep 2005
Posts: 439
Location: SW PA
|
Thanks for the advice. I'm kinda clueless about this whole screening thing thus far. I'm still a little ways off from actually doing anything but I'm trying to figure out how everything works in the meantime. I really want to find some blue prints to go off of when I build my frame. Any suggestions for that? |
|
|
Back to top |
|
|
|