| SkullandBonesSkateboards.com Forum Index » SCREEN PRINTING » board prep? |
|
Page 1 of 1 |
|
| Author |
Message |
| jerboy |
 Posted: Mon Feb 25, 2008 11:16 am |
 |
|
Joined: 02 Jun 2006
Posts: 334
Location: the piedmont
|
so i have a longboard that i want to do some printing on, its a blank that hasn't been sealed, i originally got a couple of these boards for paintings thats why i requested unsealed boards from the manufacturer.
any tips of what type of sealant to use on this? and should i seal before or after printing? |
|
|
| Back to top |
  
|
|
|
| speedwulf |
| Posted: Mon Feb 25, 2008 9:00 pm |
|
|
|
Joined: 19 Aug 2007
Posts: 39
|
| Seal it with some spray on clear lacquer.I dont know about skateboard decks but unsealed plywood will warp pretty quickly if left unsealed.You could also use clear enamel or polyurethane. |
|
|
| Back to top |
|
|
