SkullandBonesSkateboards.com Forum Index » DOWNHILL / SPEEDBOARDING / LONGBOARDS » Does anyone know the diameter to redrill truck bolts? |
Page 1 of 1 |
|
Author |
Message |
LongwoodSk8er |
Posted: Wed Feb 01, 2006 7:11 pm |
|
|
Joined: 06 Feb 2004
Posts: 161
|
I'm thinking about buying a Madrid 8 Ball deck and redrilling the wheelbase back an inch and half. Does anyone know the drill bit size to use? In the past I'vbe never been able to get the holes perfectly lined up. Any suggestions? |
|
|
Back to top |
|
|
msk |
Posted: Thu Feb 02, 2006 12:04 am |
|
|
Joined: 26 Aug 2004
Posts: 606
Location: 1/2 way between Dogtown and the Badlands
|
When I'm changing wheelbase, what I do is put a few strips of masking tape down roughly where the new holes will go, then line up a straight edge with the centers of the existing holes. Use that to draw lines on the masking tape, then put a baseplate over that, line up the centers of the holes with the lines you just drew, and mark with a pencil. Works perfectly for me every time... |
|
|
Back to top |
|
|