| SkullandBonesSkateboards.com Forum Index » GENERAL DISCUSSION FORUM » Mini halfpipe screw up, need help |
|
Page 1 of 1 |
|
| Author |
Message |
| Count |
 Posted: Thu Oct 01, 2020 5:10 pm |
 |
|
|
Joined: 01 Oct 2020
Posts: 1
|
Hi guys building this for my kids, it's 3. 2ft x 12 ft, and I cut all the transitions with a 6 ft radius. The issue is, the bottom of that radius goes past the platform line by . 5", so the flat start 9" too soon, if I continue the cut .5" lower I would need to rip some 2x3 lumber to have a lower platform. Is this necessary or will the kids be okay with the tighter bottom to the flat. I have no sheathing on yet so just looking for feedback.
Thanks |
|
|
| Back to top |
 
|
|
|
| Buddur |
| Posted: Fri Oct 23, 2020 6:29 am |
|
|
Joined: 04 Aug 2012
Posts: 1096
Location: Western Pennsylvania
|
How did I miss this thread, and everyone else for that matter.
At this point just go with what you have and start the flat like you have it, don't lower the platform. Once the surface is applied I doubt that that transition from flat will be in your face apparent. For mini ramps, the more flat the better alot of people will tell you. |
_________________
It's not the size of the deck, it's how you ride it. ...................I said "DECK"! |
|
| Back to top |
|
| rorybecnel |
| Posted: Tue Oct 27, 2020 8:50 pm |
|
|
|
Joined: 27 Oct 2020
Posts: 1
|
| That is very helpful! thank you |
|
|
| Back to top |
|
|
|
|
