| SkullandBonesSkateboards.com Forum Index » NON SKATEBOARD RELATED SALES AND AUCTIONS » Selling off NOS CNC components/electronics |
|
Page 1 of 1 |
|
| Author |
Message |
| waxux |
 Posted: Thu Jul 22, 2010 3:38 pm |
 |
|
Joined: 16 Nov 2003
Posts: 142
Location: Outer Banks NC
|
We have several items of interest to folks looking to build thier own CNC machine. Enough to more than get one started anyway....
At the very same time we desperately need a Milling Machine for the shop.
Cash on hand for a new machine purchase is beyond limited so we are looking to liquidate some of our overstock to fund the buy.
Items for sale are....
Zylotex 3 axis (pictured 4 axis) Control box and motor package. The steppers with this pack are 425 oz/in NEMA 23. This retails from Zylotex for $410.00.
This kit is NEW, however the bolt holes on the motors have been tapped for 1/4-20 hardware. This has never been used.
Includes timing pully for each motor.
Lot of 10 linear slide bearings or plain bearings Mcmaster Carr #2570K11
These retail for $5.04 ea
Lot of 8 brass spur gears. SDP-SI # A 1B 2-N24020
(retail $11.67 ea)
Lot of 12 Nylon Gear racks for above Spur gears.
McMaster Carr # 57655K63 (ret $5.33 ea)
New in Box Bosch Colt palm router ($99.00 ret)
Total retail for all of these items comes out to $716.72 before shipping if one where to buy them seperately.
As mentioned above we really need a mill soon. Make us an offer for the whole lot.
For $600 I will include 3 how to manuals for making your own machine. Between these three books are step by step plans for more than 6 different machines all can be built for very little cost.
Thanks all for taking the time.
MC |
|
|
| Back to top |
   
|
|
|
|
